ZigBee optical interface for Enel energy meter
 |
The ZR-TIDCI-OPT1-EM is part of the ZB-Connection family. It counts, stores and transmits to a Gateway of the ZBConnection 4-noks family optical pulses generated by a counter ENEL, which correspond to a certain energy measured by the latter.
|
 |
The energy per pulse is set from 1 to 99 Wh. It is also supplied with a generic digital input that can be used to transfer a state of alarm coming from outside (with contact). The internal energy meter with resolution in Wh can be reset or set to a desired value to synchronize with the ENEL energy meter. The counts are transmitted on a regular basis and to a programmable Gateway of the ZB-Connection family. The device must be continuously powered to 12-24 Vdc / Vac (power supply included); it can also act as a repeater and or a parent device for battery-powered sensors.
Key features
|
- LED pulse counter of electricity and energy meter settable from 1 to 99 Wh/pulse
- It manages electricity and energy meter in Wh
- Digital input for remote alarms
- Compatible with ENEL energy meter (single phase/three phase); other
European energy meters under development
|
Technical Specs
General characteristics
|
Chip Ember EM250
Compatible IEEE 802.15.4
Stack EmberZnet 3.5.x (ZigBee PRO)
Modbus/RTU
Device address settable via internal dip-switch
Wall mounting with screws
Cable gland: PG9 |
| RF characteristics
|
Frequency: 2405 MHz ÷ 2480 MHz
Modulation: DSSS
Nominal transmission power: 10mW (10 dBm)
Receiver sensitivity: -97 dBm
External antenna gain: 5,5 dB
Range outdoor/indoor: 200m/50m |
| Supply |
12-24 Vdc/Vac; 100mA; 50/60Hz
Power supply included 230 Vac (±20%); 50/60Hz |
| Digital input |
Electronic type not insulated inputs for clean contact
Short circuit current 0,01mA. Use self-cleaning contacts |
| Connections |
Pull out terminals (3,81 mm pitch) |
| Environment parameters |
Operating temperature: -10 ÷ +60°C; <80% U.R. not condensing
Storage temperature: -20 ÷ +70°C; <80% U.R. not condensing
Degree of protection : IP 55 |
| Approvals |
ETSI EN 300 328: Radio Compatibility for digitals wide band transmissions
ETSI EN 301 489: Radio Compatibility EN 61000-6-2: Electromagnetic Compatibility - Emissions
EN 61000-6-3: Electromagnetic Compatibility - Immunity EN 60950-1: Electric Safety |
|
ZB-Connection 
