ZigBee sensor for direct current measurements
 |
The ZED-ICC-M is a battery powered ZigBee device that can perform direct current measurements through the Hall effect sensor and send them at regular intervals to one of a Gateway of the 4-noks products family.
|
 |
This measure is based on the magnetic effect caused by the electric current fl ow along the conductor. To properly use this sensor, it should be placed on the conductor at a distance that is proportional to the amount of current that is to be measured. The range is between 0 and 1000 Acc. This device may be configured to manage alarm thresholds for exceeding maximum or minimum current levels. It is also possible to adjust the sampling and data transmission rate to improve battery life.
Key features
|
- Hall effect sensor for direct current measurements
- Range between 0 and 1000A
- Simple and quick installation, without services interruptions
- Alarm thresholds
- Sampling and transmission rates are configurable
- Battery powered
- Internal antenna
|
Technical Specs
General characteristics
|
Chip Ember EM250
Compatible IEEE 802.15.4
Stack EmberZnet 3.5.x (ZigBee PRO)
Modbus/RTU
Device address settable via internal dip-switch
Mounting on conductor which current is to be measured |
| RF characteristics |
Frequency: 2405 MHz € 2480 MHz
Modulation: DSSS
Nominal transmission power: 2mW (3 dBm)
Reception sensitivity: -95 dBm
Internal antenna gain: 0 dB
Coverage outdoor/indoor: 100m/30m |
| Supply |
AA high energy density lithium battery 3,6V/2000mAh
Battery life: 3 years in case of 1 transmission per minute at 20ºC |
| Direct current sensor |
Hall effect CSA-1V type sensor
non-linearity error <1% Sensitivity 280 V/T
Linear measurement range -5mT ÷ +5 mT
Response time <6μs
Measures represented in tenths of Ampere |
| Environment parameters |
Operating temperature: -10 € +60‹C; <80% U.R. not condensing
Storage temperature: -20 € +70‹C; <80% U.R. not condensing
Degree of protection: IP 55 |
| Approvals |
ETSI EN 300 328: Radio Compatibility for digitals wide band transmissions
ETSI EN 301 489: Radio Compatibility
EN 61000-6-2: Electromagnetic Compatibility-Emissions
EN 61000-6-3: Electromagnetic Compatibility-Immunity
EN 60950-1: Electric Safety |
|
ZB-Connection 
