2Embedcom anuncia que la nueva versión de firmware (2.6.8) para dispositivos AVL de Falcom (SteppIII, Bolero LT, Fox LT y Fox LT IP) ya está disponible.

Este nuevo firmware, para dispositivos con memoria FLASH de 8MB, incorpora las siguientes mejoras:

• Remote update
  • GSM Modem is switched off and on after firmware update
• BIOS 1.7 added
  • Extended reset reasons for Watchdog testing purposes only
    • reset,watchdog0 - BIOS hw watchdog
    • reset,watchdog1 - avl FW watchdog 1
    • reset,watchdog2 - avl FW watchdog 2
    • reset,watchdog3 - avl FW watchdog 3
• Pfal,Cnf.Set roboustness improved
  • Debug infos removed to speed up loading alarms during start (when PFAL,CNF.Set,DBG.EN=1)
• GSM
  • eMCC event is shown correctly
  • Mechanism of the operator selection improved
• PFAL commands
  • PFAL,Cnf.Backup added
  • PFAL,Cnf.Restore added
• Dynamic protocols
  • &(MONI) can be used in PFAL commands again
    • it is strongly NOT recommended to use this dynamic protocols in alarm actions
• Events
  • Sys.Info.e0
  • Sys.Info.e1
• States
  • GPS.Nav.sDeltaspeed added
• Improvements
  • GSM  AT commands handling optimized

Known issues:

• Error outputs when dialing or accepting voice calls.
• These outputs have no effect on the voice calls or the device functionality which can be ignored.
• When dialing voice calls  --> "$GPERROR:GSM: CmdErr 1" will be outputted
• When accepting voice calls --> "$error accepting call" will be outputted. However, the device accepts the call and generates the event "GSM.Voicecall.eEstablished".

Descargas:

• Firmware y Release Notes
• Manual de usuario